V-HP-SF-1000

The boiling chamber is negative pressure at -95 to -97kPa under vacuum condition, raw material is automatically sucked into chamber under negative pressure. Meanwhile, the heat pump system will makes heat exchange device into evaporation and condensation two parts. Circulation system sprays raw wastewater onto the evaporation part nebulized, water become steam after evaporation and rise to condensing become condensate. The condensate flows to condensation vessel and the concentration remains in boiling chamber, both of them will discharge automatically when reach pre-setted rate. 

The heat pump low temperature evaporator has many unique advantages.

Compared to conventional evaporators,Its energy saving effect can reach more than 90%.Its unique heat source heating method. Use the heat source of the compressor for heating,Using the cold amount to condense, no additional cooling water supply is required. In this way, not only save the cost of cooling water supporting facilities, it also reduces the cost of electricity consumption and other supporting facilities to a certain extent.

The device does not require additional steam or other auxiliary heat sources.It only needs power to run.Simplifies the operation.It also reduces the cost of supporting facilities and maintenance costs to a large extent. Its low temperature evaporation properties,

the vacuum degree can reach -97KPa,The evaporation temperature is about 35℃,

Especially suitable for handling heat sensitive materials.

The heat pump low-temperature evaporator also has the characteristics of fully automated control and operation, without manual intervention. Compared to other evaporators. It's easier to operate, it's more automated, lower failure rate and more stable operation. At the same time, the modular design makes the assembly and operation of the equipment more convenient and occupies a very small area.